Share:
Share
Notifications
Clear all

about simplify 3d settings. / nozzle stop extruding for long period .

adhamskeini
(@adhamskeini)
Member

dear frients, and expert, 

Im using simplify 3d as a slicer, and I have a printer with direct extruder, but im facing a problem that suddenly the nozzle stops extruding filament, for 20 % of the layer, then resume again, I tried to increase extruder multiplier, increased width, droped the velocity, still the same problem, currenty I set up the retraction at 1 mm , and I even stopped retraction, and it is still the same problem, any idea how to resolve this issue. 

Quote
Topic starter Posted : 26/07/2020 5:48 pm
Luke
 Luke
(@lmf5000)
Expert Moderator

Hi Adham,

Welcome to the community! 🙂

Could you export your profile and upload the .fff file as an attachment? I suspect it'll be a problem in the wipe/coast settings (you can check those before you upload) but I will check the whole thing and let you know if I find anything out of place 🙂

Regards,
Luke

ReplyQuote
Posted : 26/07/2020 10:49 pm
Share:
Share

About us

We’re a bunch of 3D printing and design nuts. We just want to make great 3D design available to everyone. 

Our mission

Good design takes time, great design takes a process. You can learn this with us, to build your skill set in this rapidly expanding market. 

Learn with us:

© Copyright: 2019 io3dp.com
Close Menu