Share:
Share
Notifications
Clear all

How to add reinforcement around hole area using PrusaSlicer

SubseaUK
(@subseauk)
Member

Hi, to keep this as simple as possible, I have a cylinder with a diameter of 240mm x 200mm high and a wall thickness of about 7-10mm. I need to print or drill 3 6mm dia holes at a 120deg spacing around the cylinder which is printed with Flexfill98A and would like to reinforce these holes. Can someone tell me how to go about doing this with PrusaSlicer please?

Thanks

Quote
Topic starter Posted : 30/03/2021 8:03 am
Luke
 Luke
(@lmf5000)
Expert Moderator

Hi Kev,

Didn't see this earlier - I answered you in your other thread but you can post replies here. If you need more specific guidance save your project as a .3mf and we'll fine-tune it if needed. There might be a more efficient way than using modifiers depending on the orientation and positioning of the holes.

Regards,
Luke

ReplyQuote
Posted : 30/03/2021 3:42 pm
Share:
Share

About us

We’re a bunch of 3D printing and design nuts. We just want to make great 3D design available to everyone. 

Our mission

Good design takes time, great design takes a process. You can learn this with us, to build your skill set in this rapidly expanding market. 

Learn with us:

© Copyright: 2019 io3dp.com
Close Menu